https://forum.d5t5.com/tags/pinRSS for NodeThu, 23 Apr 2026 10:21:32 GMTInvalid Date60@johnzero Decoding with the VDD is a standalone process, no laptop/DICE needed. When it is successful, the pin will be added to the Vdash database and you can start using Vdash on the car.
The car can't be used or locked while decoding. It will enter programming mode after you start the decode process. This means the car is clicking here and there, and then goes completely dead. Never start the decode when the engine is running!!!
The decode can be started without a key in the car. You should still unlock to be able to open the hood/disconnect the battery if the process crashes.
As the decoding might take up to 8 hours with the VDD, you should indeed connect a charger while decoding. The process can of course be paused and continued later. You might also want to use an OBD Extender cable to place the dongle behind the windshield for better mobile network signal.
BTW: I have never been able to successful perform a decode with my VDD, because it was always aborting/crashing after around 30-120 seconds with the car not fully waking up from programming mode afterwards. The support was never able to figure out why, so I bit the bullet and decoded the classic way.

]]>https://forum.d5t5.com/topic/303/cem-pin-decoding-with-vdd-dongle-only-no-dice-clarification-neededhttps://forum.d5t5.com/topic/303/cem-pin-decoding-with-vdd-dongle-only-no-dice-clarification-neededInvalid Date