Volvo V50 2 D 2006 injectors coding
-
Hello.
I had replaced the engine mounts from my Volvo V50 2 D 2006, and now I was feeling the engine vibration in the cockpit, which reduced the car's comfort. From the errors reading from the VIDA or VDASH software, I didn’t find any error that could explain the engine shaking.
I remember that previously I had changed, by myself, one worn injector, and I didn’t update the injector's code. To perform this update, I bought the subscription (Invoice nº 26500479) and a SUPER J2534 Volvo Dice cable (invoice 26500587), however, when I connect my car to your software, I don´t find the injector coding tab, as I saw in some YouTube videos performing the injector coding update with the VDASH.
My car is at the Volvo P1 platform with a D4204T engine, and a chassis nº 190891. During the injector replacement, I was careful and changed the worn injector with one of the same injector class, being this 5. So, all the injectors are from class 5 and from the information available at https://d5t5.com/article/volvo_diesel_injectors, the injector coding from Cylinder 1 and Cylinder 2 must have the injector code 36000318, while the injectors from the cylinder 3 and Cylinder 4 must have the injector code 36000319.
Nevertheless, the injector coding update present in the YouTube videos shows that the code used was from the injector itself. In the figure below, you can see that the injector code is 9657144580 or EI17 42543, and this number is too different from your tabled values, and also, those values presented in the injector itself are changed from one injector to another.
So, first, I would like to understand why the injector's code tab does not appear in my software. And which injector codes are the right ones to use for the update?
I will be waiting for your response.Thanks in advance
Rodrigo
-
According to VIDA, your engine doesn't need IMA coding, just setting the correct injector class (4,5,6) in the ECM which has to be the same in all cylinders. What options do you see, when you click on the ECM when the car is connected. And did you install a new or a rebuild injector?
-
@RuRU in VIDA this option is located in Diagnostic/Communication/ECM/Advanced->Programm optimization parameters. But as you didn't change injector class, this shouldn't be necessary. You might want to try resetting adaptions located in the same path. Clear all DTCs before performing this. Those options should also be available in Vdash after clicking on the ECM.
