hi, yes I had already seen this page and changed the connectors. the injector is ok because even when I disconnect the cable the error appears. which does not happen when I disconnect the cable of injector 4. I checked the cables and also the insulation.. everything is ok. I will tell you more I get the error even if I disconnect the large connector of the ECU leaving only the small one connected which is power supply

Hi everyone
I have a question. Is the original software present in Vdash the latest update from Volvo?
Or once installed do I have to do the updates at the Volvo dealer?

Hi
these error appear only when the car is off for two minutes and then switches to injecton on. The error does not appear when the car is running.

In DTC this error means "Injector power stage, cyl 5. Signal too high".

I've check the cable and injector and all Is ok. If I unplug the injector 5 the error Is present. I tried swapping the cables between 4 and 5 injector and the error is ever 26B0. Could the ECM be faulty? Do you think if I reprogram it with vdash could the problem be solved?