Help please, did I brick my DDM? 2007 p2 xc70
-
Long story short, this is my project car, and I have been trying to add BLIS to it. I have only got the mirrors and the mirror caps off from a 2007 s60 (blis worked no issues on donor car), but not the driver and the passenger door modules.
I have unlocked/enabled BLIS on CEM but it kept throwing camera error codes for both sides (4f47 and 4f48). I have went through a lot of stuff, wiring is correct, ddm and pdm sees the modules (3 lines of serial numbers).
Then I have thought if I update the software on the driver and passenger doors that should enable blis to work properly?
I have updated PDM no issues, but when I tried to update DDM it kept bricking at the last "detecting" - "detect finished 0 of 1 ECUs alive" sequence.
It keeps throwing the same "Unit DDM is not responding. Restore software of the unit from backup." and "Unit DDM is not responding."I have tried everything I could think of. I have disabled blis on CEM again, I have pulled the pdm fuse, I have power cycled the whole car and the DDM separately, and it still says the same thing. I would like to say that prior to me messing with the software both DDM and PDM worked without issues and had no error codes other than the BLIS ones.
Please throw me any ideas that could help.
-
A few updates since, Vdash team sent me an update once, but it didn't change anything.
I have tried it with a full chip dice, blis enabled, disabled no difference,
I have tried it with the original mirror no difference
I have tried it with a LOT newer DDM blis enabled and disabled (from a 2013 xc90), it did the exact same thing
I have tried it after reverting the PDM to the original settings no differenceI am out of ideas and I have spent hundreds on it so far...
PDM update went through no issues straight away, BOTH DDMs are installing the update and then 20% into the detection they go bootlooping.
PDMs are alive but bootlooping, confirmed by vida.
