In this case, I should go with Vida to do all the configuration, that way I would be safe

Oh, thanks for the information. That means, if I ever sell the car I would need to revert all changes before selling it (which would remove headlight and blind spot sensor configuration) ?

I need to configure my headlight and blindspot sensor so I will need the PIN, just debating wether I buy Vdash or OrBit

Yes, when I click connect it opens the vehicle detect tab, in this I can click READ TCD, but it doesn't show tdc just the error code.
I was sitting no the driver seat and had the car in D, not it N maybe that's my issue. Also driver door was open

I don't see any module in the page, I only see that it's connected to the car, but it shows no information other than the VIN
I don't have 3rd party antivirus or security, just basic Microsoft stuff.

Note, in the vehicle detect page I also don't have the mileage or service information

Hi ! I installed vdash on my laptop yesterday, my car is detected but when I click Read TDC or Clear TDC I get a pop up window with Command Not Found in it. No TDC shows up. I currently have the front bumper off so there should be some TDC to show.

I use a VOE cable,and I have to put the car in drive (D) in order for vdash to see it