P3 (V40II, V40CC, S60II, V60, XC60, V70III, XC70III, S80)

Not possible. There are various OBD HUD displays for this, or countless apps for mobile phones like Car Scanner ELM OBD2, that just require an OBD-dongle like a vLinker MC+ or OBDLink MX+, and show all parameters that are provided by the ECUs that are installed in your car. Except oil pressure. Volvo uses simple oil pressure switches on most of their engines that switch on/off at a specific pressure value and give a warning when the pressure is below a specific pressure value. If you want to see absolute pressure values, you have to install an aftermarket solution for that.

@JONT3pro Nope. You need to add a resistor or use Canbus compatible LEDs.

Heya,

for me at least, if I recall correctly the original it was the bottom option.
I switched to the User configurable DRL's though.
Med vänliga hälsningar

V40 N00B

How much does AI decoding cost?

@ps603 "application" and "remove" = parameter change in the CEM or specific Ecu. "Reload" and "upgrade" = Ecu firmware.

You can do this with vdash. Different level sensors and rewiring is also needed.

How do I remove four C from my 2010 Xc70?